Specification for plastic flooring installation

Summary surface:

Plastic floor is a very popular floor material in the market at present, which belongs to a new type of light floor decoration material. It has the advantages of waterproof, fireproof and anti-skid. Today, this article mainly introduces the installation specifications of plastic floor. Standard installation is an important guarantee for plastic floor not bulging.

微信图片_20241111110220

1.Environment condition

When the indoor temperature is below 10℃ (glue manufacturers generally recommend not to install plastic floors below 18°C), it is not allowed to install plastic floors. The glue does not dry at low temperature and is not suitable for bonding. Technicians must prevent cream glue from frosting. The place where glue is used must be well ventilated.

微信图片_20241111142502  微信图片_20241111142503  微信图片_202411111425021

2.Floor condition

It is necessary to fully consider whether the ground is non-absorbent or water-absorbent. Tiles, marble and metal floors are non-absorbent and others are basically absorbent. Appropriate selection of different base oils. This can avoid the phenomenon of self-leveling not adhering to the surface and shelling caused by improper selection.

微信图片_202411111425031  微信图片_202411111425032

3.Construction specifications

Construction specification is a very important link to the bonding of plastic floor.

Proper use of glue: The glue must be applied in accordance with the manufacturer’s instructions, using a serrated hand spatula of the recommended type, and must be applied evenly. If not according to the manufacturer recommended glue application amount, the glue can’t give full play to the role of sticking plastic floor. If there is not enough time for the glue to evaporate, there may be moisture or solvent residue in the glue, which may lead to bond failure.

Rolling: A 50 kg steel roller shall be used to roll the entire surface of the floor evenly to compact the plastic floor. Roll out the plastic floor from the center of the floor, at least twice, immediately after the floor is installed, and then again between half an hour or one hour after the floor is installed.

Because the final adhesive force of the glue is in half an hour, the plastic floor has properties, in it is not completely adhered before, there will still be some bulging phenomenon, so need to roll again to make the plastic floor very good with the glue adhesive. Use rolling to press the back of the floor and the adhesive, ensure that the floor does not have bubbles, and the plastic floor is well bonded.

If the floor is used before the glue is completely dry, the weight of the floor may leave an indelible mark.

微信图片_202411111425033


Post time: Nov-11-2024